Installation Guide and Users ManualWall Mount Range Hood168/198 Series Wall Mount Range HoodIMPORTANT:Read and save these instructions.NOTICE:Installe
Page 8Electrical RequirementsIMPORTANT: Observe all governing codes and ordinances. (Please consult with a qualied electrician for 220-Volt 50 Hz vol
Page 9Advanced Preparations:Read the entire installation guide and users manual thoroughly, understand instructions and warnings.1. Be familiar with t
Page 10Installations (refer to Page 4 for parts):Measure the distance between stove top and the bottom of range hood. A distance of 28” to 31” is reco
Page 11Store excess wires in the wiring box.6. Install both chimneys and tighten screws to secure the 7. lower chimney to the range hood as shown in F
Page 12Page 12Installation (Note)
Page 13Power SwitchLow SpeedMedium SpeedHigh SpeedLight SwitchRange Hood Operations & Wiring DiagramTurn On:Press the speed control (Low Speed, Me
Page 14This range hood is equipped with a credit card size remote control (approximately 20ft range), three built-in elec-tronic controls, a powerful
Page 15The credit card size remote control controls the power of the Lights , Power-Off Delay , Power (ON/OFF) and Fan Speeds: Quiet (F1), Low (F2)
Page 16Range Hood Operations & Wiring Diagram (Continued)SV168/198 Series “R” Class Wiring DiagramNOTE: Wiring Diagrams shown above with GU10 ligh
Page 17This range hood is designed to remove smoke, cooking vapors and odors from the cook top area. For best results, start the range hood before co
Page 18Controls:• Adjusting the timer function:• While the blower (motor) is not running, press and hold • Decrease Value button over 3 seconds to en
Page 19Range Hood Operations & Wiring Diagram (Continued)SV168/198 Series “E” Class Wiring Diagram (4 Speed)NOTE: Wiring Diagrams shown above with
Page 20TroubleshootingIf the range hood or halogen light does not operate 1. after installation:Check if the range hood has been plugged in, make • su
Page 21Specications*:Body Stainless Steel / Tempered GlassPower Rating 220V/50Hz or 120V/60Hz (USA & Canada standard)General Input Power 120W + #
Page 22SAFETY WARNING: Never put your hand into area housing the fan while the fan is operating!For optimal operation, clean range hood & all lte
Page 23Maintenance (Continued)Replacing J4 Type Halogen Light Fixture:This range hood uses halogen light xture: 20W 12V (Product ID: SV-ACS-HAL20W).•
Page 24WARNINGHazard of Burns!Light bulb become extremely hot when turned on. DO NOT touch bulb until switched off and cooled. Touching
Page 25One Year Parts Warranty:For one year from the date of original purchase, your local reseller will provide free of charge, non-consumable replac
Page 26Carefully inspect all items for damages before accepting delivery. note any damages on the freight bill or express receipt. request name and si
Page 27Your Notes
Important Safety NoticeRead all Instructions before Installing and operating this applianceThe installation in this manual is intended for qualied in
Page 28Your Notes
Page 29Your Notes
Aus-Tex Appliance113 Industrial Blvd #DAustin, TX 78745Tel: 512.444.2775
Page 2Important Safety NoticeRead all Instructions before Installing and operating this applianceThe manufacturer and/or distributor/reseller declines
Tools needed:Page 3LevelFlat-blade and Phillips screw-driversPowered screwdriver or drillMeasuring tapeUtility knifeMarker or pencilTable of ContentsI
Page 4Air diverter(Optional re-circulating kit)Charcoal Filter(Optional re-circulating kit)Description QuantityToggle Bolts 2 PcsDuct Set 1 SetBody Ho
Page 5Max*: 110”StandardUpperChimneyExtension available*Range hoodMounting BracketStandardLowerChimneyExtension available*36” baseMaximum* ceiling cle
IMPORTANT:A minimum of 6” round (standard for this range hood) or 3-1/4 x 10” rectangular duct (purchased separately) • must be used to maintain maxim
Venting MethodsPage 7This range hood is factory set for venting through the roof or wall. For non-vented (re-circulating) installa-• tions, see Recirc
Comentários a estes Manuais